dimensions are shown in mm (inch) dimensions subject to change 105 sf2 rf coaxial connectors sealflex 2 tm introduction itt cannon?s sealflex 2 microwave cable as- semblies are designed for applications requiring consistent microwave performance through to 18 ghz and may be used with minimal degradation to 26 ghz, with sma connectors. all connector designs, except bnc, exhibit ?mode free? characteristics to 18 ghz, thereby allowing low vswr to be specified without ?spikes? being present in the upper frequency spectrum. each assembly is 100% tested for vswr and insertion loss and test plots are supplied with each item. sealflex 2 assemblies have been adopted for use in various avionic systems, missiles, military ground and shipborne applications as well as commercial communications equipment; in fact, anywhere where cost effective high performance and reliability is paramount. specification electrical impedance 50 nominal voltage standing wave ratio (vswr) 1.25 (2 - 12.4 ghz). 1.35 (12.4 - 18 ghz) attenuation see graph on next page shielding rf ? 90 db mechanical connector retention 137 n (30.9 lbs.) minimum connector/cable torque 1.7 nm (15 in. lbs.) minimum minimum bend radii cable diameter static flexing 3,18 (.125) 13,00 (.511) 25,00 (.984) 4,57 (.180) 19,00 (.748) 38,00 (1.496) 6,35 (.250) 25,00 (.984) 51,00 (2.007) environmental operating temperature ? 65 c to 165 c moisture resistance mil-std-202, method 106 vibration mil-std-202, method 204(c) shock mil-e-5272, para 4.15.5.1 thermal shock mil-std-202, method 107(c) corrosion mil-std-202, method 101(b) solvent resistance 7 days at 200 c, jp6 (mil-j-2658) and hydraulic fluid (mil-h-5806) notes tighter specifications to special quotation. sealflex 2 assemblies are manufactured under licence to times fiber communications this product is not available in north america through itt cannon
dimensions are shown in mm (inch) dimensions subject to change 106 rf coaxial connectors sealflex 2 tm specification attenuation typical return loss (vswr). part number 065-9aa-1000000 cable maximum frequency (f c ): x 3,18 (.125) = 65.3 ghz (single mode operaton) x 4,57 (.180) = 36.8 ghz x 6,35 (.250) = 23.7 ghz
dimensions are shown in mm (inch) dimensions subject to change 107 sf2 rf coaxial connectors sealflex 2 tm microwave cable assemblies length - to interface on straight connectors - to centerline on right angle connectors - to front of flange on bulkhead connectors standard tolerances: length up to 1m (39.370) -0 + 10,00 (.393) 1m (39.370) to 3m (118.00) -0 + 20,00 (.787) 3m (118.00) to 15m (1771.65) -0 + 30,00 (1.181) ordering information connector type code sma plug a sma right angle plug b sma bulkhead jack, ?d? hole c sma bulkhead jack, 4 hole flange d sms bulkhead jack f sms bulkhead plug, float mounted g bnc plug h tnc plug j tnc right angle plug k tnc bulkhead jack, ?d? hole l tnc bulkhead jack, 4 hole flange m tnc free jack n k male p n plug s n right angle plug t n bulkhead jack, ?d? hole u n free jack v n jack, 4 hole flange w apc-7 z cable size code 4,57 (.180) 0 3,18 (.125) 1 6,35 (.250) 2 part number explanation 065 - 9xx - xxxx x00 microwave cable assembly connector 1 code connector 2 code length (mm) for lengths of 10 m and over contact sales department 0 - standard 0 - standard 1 - armoured sealflex 2 cable size code example 065-9bl-0720000 sealflex 2, 4,57 (.180) assembly with 1 x sma right angle plug and 1 x tnc bulkhead jack ?d? hole 720,00 (28.346) between center line of sma and front of flange of tnc, -0 + 10,00 (.393) stock assemblies the following part numbers are held in stock: length 2 x sma plug sma plug/n plug 2 x n plug 300,00 (11.811) 065-9aa-0300000 ? ? 500,00 (19.685) 065-9aa-0500000 065-9as-0500000 065-9ss-0500000 750,00 (29.528) 065-9aa-0750000 ? ? 1000,00 (39.370) 065-9aa-1000000 065-9as-1000000 065-9ss-1000000 1500,00 (59.055) 065-9AA-1500000 ? 065-9ss-1500000 2000,00 (78.740) 065-9aa-2000000 065-9as-2000000 065-9ss-2000000 3000,00 (118.110) 065-9aa-3000000 ? 065-9ss-3000000
|
